Skip to main content

Post content has been hidden

To unblock this content, please click here

Victoria
Savvy October 2017

Soldering wedding band

Victoria, on October 24, 2017 at 1:14 PM Posted in Etiquette and Advice 0 9

Has anyone done this? How did you like it? Cost? Pros/cons?

Mine slide around, so I'm looking into options.


9 Comments

Latest activity by Brittney, on October 24, 2017 at 4:30 PM
  • Shannon
    Devoted June 2017
    Shannon ·
    • Flag
    • Hide content

    Mine are soldered. It was free from the jeweler.


    • Reply
  • VC
    Super April 2018
    VC ·
    • Flag
    • Hide content

    Same as PPs. Mine will be included. But the jeweler recommended I get them soldered together to prevent them from sliding. They have similar divets to yours... I have a band for each side, so sliding isn't going to be option for me. That would drive me absolutely nuts.


    • Reply
  • Rebecca
    Devoted March 2018
    Rebecca ·
    • Flag
    • Hide content

    My FSIL is a jeweler and advised against it, you may just want to wear just the band in the future, on vacation etc.

    • Reply
  • Padilla
    Savvy October 2017
    Padilla ·
    • Flag
    • Hide content

    I will be soldering mine. They move around way too much and I am constantly fixing them.


    • Reply
  • Jaclyn
    Super September 2018
    Jaclyn ·
    • Flag
    • Hide content

    I'll be soldering mine together. My band slides no matter what it's so frustrating. It will look a lot better in my opinion.


    • Reply
  • The Trap Selena
    Master March 2016
    The Trap Selena ·
    • Flag
    • Hide content

    I hated it. I had them separated. It was about $70 to solder and the same amount to have them separated at a private jeweler. They should've been sized up and it made the band too thick on the palm side of my finger.

    • Reply
  • mrsmack
    VIP April 2017
    mrsmack ·
    • Flag
    • Hide content

    I have a wrap and I would never wear the e-ring without the wrap, so I had them sized and then soldered. I love it, although it does make it a pain to clean sometimes. But it does feel more comfortable on my finger than they did when they were separate.

    • Reply
  • Victoria
    Savvy October 2017
    Victoria ·
    • Flag
    • Hide content

    What about getting the rings resized after they are soldered? Is it possible?

    My wedding band is contoured and I would never wear my band without the E-Ring. Plus it slides, and I'm constantly readjusting it. At the moment the rings are too big (lost weight), but I will be using a ring size adjuster for awhile in case I lose more weight and my hands get even smaller.

    • Reply
  • Brittney
    Devoted September 2018
    Brittney ·
    • Flag
    • Hide content

    I still be soldering mine because it fits to the e-ring. I won't wear the band alone because it's shaped to fit the e-ring, not to be a stand alone ring. Also, it would be annoying to me to have it get off center all the time.

    • Reply

You voted for . Add a comment 👇

×

Related articles

WeddingWire celebrates love ...and so does everyone on our site! Explore how we embrace diversity

Groups

WeddingWire article topics