Lafuturaseñora
Devoted April 2019

Finishing up my Invitation suite... separate cards?

Lafuturaseñora, on February 4, 2019 at 8:48 PM Posted in Etiquette and Advice 0 5
Saved Save
Reply

Hi yall I'm finishing up my invitation suite online so far I've completed my initial invitation & the RSVP card.

I know I make a separate card for the reception since it's in a different venue, but is it on the "Reception" card (title) or the "Details" card? if I make a reception card what do I put under a details card....thanks in advance. Figuring out all these cards is bout to do me in 😂

5 Comments

  • Chandra
    Master May 2019
    Chandra ·
    • Flag
    This is our details card.
    We had a separate one or hotel info

    Finishing up my Invitation suite... separate cards? 1
    • Reply
  • Lafuturaseñora
    Devoted April 2019
    Lafuturaseñora ·
    • Flag
    View Quoted Comment

    Awesome thank you!

    I have the ceremony information on the invitation, should I repeat it on the details card?


    • Reply
  • Chandra
    Master May 2019
    Chandra ·
    • Flag
    View Quoted Comment
    I dont know if its necessary both places, but that's what I did too. Haha
    I mostly just needed to take up room.
    You could always put info on parking if there is anything unique about it, shuttle info if available, things like that!
    • Reply
  • Lafuturaseñora
    Devoted April 2019
    Lafuturaseñora ·
    • Flag
    View Quoted Comment

    Haha i see! I think it's nice to see all the times and addresses on the same card, so I think I will repeat it on a details card.

    Thank you again, I'll probably write a note about our website too!

    • Reply
  • earias
    Champion December 2017
    earias ·
    • Flag
    You can actually choose to put the reception information on the invitation. It's a matter of preference. I chose to do that. Then I had a details card with our website on it.

    Finishing up my Invitation suite... separate cards? 2

    Finishing up my Invitation suite... separate cards? 3
    • Reply

Comment on this discussion

×